On May 11, 11:42 pm, "Larry Linson" <boun...@[EMAIL PROTECTED]
> wrote:
> In some earlier versions ofAccess, if you save too early in a
manualim****t
> process, theIm****t-Ex****t Spect may not reflect all (or any) of the
changes
> you made. Try im****ting, creating the specification, and saving at the
very
> end of theim****tprocess. As I am not in a position to test
inAccess2007, it would be helpful if you would post your results back to
this
> message thread.
>
> Larry Linson
> Microsoft OfficeAccessMVP
>
> <davjoh...@[EMAIL PROTECTED]
> wrote in message
>
>
news:2ac954af-8f0f-4a72-a428-d1e30ca1ea66@[EMAIL PROTECTED]
>
> >I havesavedanim****tand it works great. I would like to be able to
> > start thesavedim****tfrom a button on a switchboard. I tried using
> > TransferText and thesavedim****tname but it does not recognize the
> >savedname as anim****tspecification.
>
> > Thanks for any help
I went looking for the MSysIMEXSpecs table to verify that the im****t
spec was saved. Was not able to find it.
|
