Re: roll back to 8.1 for PyQt driver work-around

Scott Frankel a écrit :
>     [...]
> Here's the full text from the log file:
> 
> FATAL:  syntax error in file "/Library/PostgreSQL8/data/postgresql.conf"

> line 107, near token "kB"

You can't use units in a pre-8.2 config file.

> FATAL:  syntax error in file "/Library/PostgreSQL8/data/postgresql.conf"

> line 107, near token "kB"
> LOG:  could not bind IPv6 socket: Address already in use
> HINT:  Is another postmaster already running on ****t 5432? If not, wait 
> a few seconds and retry.

Apparently the 8.3 server is already running on ****t 5432... which seems 
plausible because I think you launch 8.1 on the 8.3 data directory.

> FATAL:  incorrect checksum in control file
> LOG:  could not bind IPv6 socket: Address already in use
> HINT:  Is another postmaster already running on ****t 5432? If not, wait 
> a few seconds and retry.
> FATAL:  incorrect checksum in control file

It means you try to execute an 8.1 server on a data directory 
initialized by an 8.2 or 8.3 initdb.

> LOG:  could not bind IPv6 socket: Address already in use
> HINT:  Is another postmaster already running on ****t 5432? If not, wait 
> a few seconds and retry.
> FATAL:  incorrect checksum in control file
> LOG:  could not bind IPv6 socket: Address already in use
> HINT:  Is another postmaster already running on ****t 5432? If not, wait 
> a few seconds and retry.
> 

You can use two different release on the same server. But you need 
different ****t number and different data directory.

Regards.


-- 
Guillaume.
  http://www.postgresqlfr.org
  http://dalibo.com

-- 
Sent via pgsql-general mailing list (pgsql-general@[EMAIL PROTECTED]
)
To make changes to your subscription:
http://www.postgresql.org/mailpref/pgsql-general