Re: Can't create DSN using SSPI authentication WinXP to

No success.

I have been using 08.03.0100.

I deleted the libpq.dll like you say and then I get the following setting
u=
p the ODBC:

If I choose "Allow" in the SSL dialog, I get the error message "Unknown
aut=
horization type"
If I choose "Require" in the dialog,  I get the error message "Could not
co=
nstruct a socket to the server"

Is there something I need to do on the server side?
I tried putting SSL=3DOn in the postgresql.conf file on the server but the
=
service would not restart after I did this.
In the pg_hba.conf file, I have been using "host   all     all     
0.0.0.0=
     0.0.0.0    sspi"

Thanks,
Roger

Roger M. Quincy, PG
Hydrologist
Texas Water Development Board
Ground Water Technical Assistance Section
phone: 512-936-0833
email: rquincy@[EMAIL PROTECTED]
 http://www.twdb.state.tx.us/GwRD/waterwell/well_info.asp

>>> "Hiro**** Saito" <z-saito@[EMAIL PROTECTED]
> 4/29/2008 5:22 PM >>>
Hi.

Please use the installer package(08.03.0100).
Then, remove libpq.dll there. and use set SSL select of dialog.

Regards,
Hiro**** Saito




--=20
Sent via pgsql-odbc mailing list (pgsql-odbc@[EMAIL PROTECTED]
)
To make changes to your subscription:
http://www.postgresql.org/mailpref/pgsql-odbc