Hi.
Ahh, Ok.
In the first, since libpq.dll of psqlODBC(08.03.0100) are 8.2 bases,
Therefore, SSPI is not
sup****ted. However, psqlODBC had a peculiar SSPI module in a trial way.
Then, I have the
result of only the SSL use of that. They are not many patterns though
regrettable...sorry.
Probably, you are using PG Version 8.3. Then, It seems that it still has
many problems.
As a possibility, using libpq.dll of 8.3 bases may have a good result. or,
DEBUG of the SSPI
module of psqlODBC is required. However, much time is required....
Regards,
Hiro**** Saito
----- Original Message -----
From: "Roger Quincy" <Roger.Quincy@[EMAIL PROTECTED]
>
No success.
I have been using 08.03.0100.
I deleted the libpq.dll like you say and then I get the following setting
up the ODBC:
If I choose "Allow" in the SSL dialog, I get the error message "Unknown
authorization type"
If I choose "Require" in the dialog, I get the error message "Could not
construct a socket to the
server"
Is there something I need to do on the server side?
I tried putting SSL=On in the postgresql.conf file on the server but the
service would not restart
after I did this.
In the pg_hba.conf file, I have been using "host all all
0.0.0.0 0.0.0.0 sspi"
Thanks,
Roger
Roger M. Quincy, PG
Hydrologist
Texas Water Development Board
Ground Water Technical Assistance Section
phone: 512-936-0833
email: rquincy@[EMAIL PROTECTED]
http://www.twdb.state.tx.us/GwRD/waterwell/well_info.asp
>>> "Hiro**** Saito" <z-saito@[EMAIL PROTECTED]
> 4/29/2008 5:22 PM >>>
Hi.
Please use the installer package(08.03.0100).
Then, remove libpq.dll there. and use set SSL select of dialog.
Regards,
Hiro**** Saito
--
Sent via pgsql-odbc mailing list (pgsql-odbc@[EMAIL PROTECTED]
)
To make changes to your subscription:
http://www.postgresql.org/mailpref/pgsql-odbc
--
Sent via pgsql-odbc mailing list (pgsql-odbc@[EMAIL PROTECTED]
)
To make changes to your subscription:
http://www.postgresql.org/mailpref/pgsql-odbc
|
